SUBJECT : Method to set DPM value (if display is going to Standby mode after disconnecting the input source)
■ DPM is Display Power Management. If this function is enable then set will go to standby mode after the defined time (which is set in menu)
■ To enable or disable this function you need to enter into Installation Menu
■ Please check Power and IR Sensor cable thoroughly
How to Setup
■ Press and hold the setting button for 5 seconds
■ When Input ID bar displayed (on the top right corner) then enter password (Default password is 0000) and press Ok.
■ When Installation Menu display the select Signage Setup option
■ Go to DPM option and set value to OFF or desired timing (5sec/10sec/15sec/1min/3min/5min/10min)
■ If you have selected OFF then display will never go to Standby mode but if you selected the time then display will go to
standby mode after the selected time period when you have disconnected the input source.
If the problem is not resolved, please call LG Support representative on 1800-180 -9898 (Toll Free)
or any loss or damage whatsoever arising from loss of data or profits arising out of or in connection with the use of this informational video.
•No part of this text or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author.