Installation and product overview [Air Purifier]
Congratulations on your purchase of this LG Air Purifier product.
INSTALLATION
Unpacking the Appliance
- Take the product out of the box, and remove the packaging and tape attached to the product.
- While facing the front of the product, hold and gently pull both sides of the air inlet (cover) to remove it.
• The side with the LG logo on the display of the product is the front of the product.
- Remove the filter and dispose of the packaging.
- Install the filter in the product.
• Make sure that the side with the filter handle (❶) is facing up.
- To reinstall the cover, insert the tabs at the bottom of the cover into the groove at the bottom of the product and close the cover.
• When installing the filter, pay attention to the direction of the filter.
- Failure to do so may cause malfunction or product failure.
- The side with the filter handle is the top.
Transportation Requirements
• Before moving or storing the product, wrap the cord around the lower part of the product to keep the power plug from touching the floor.
- Failure to do so may damage the power plug or scratch the floor.
• Do not transport the product by holding its exterior cover.
- The cover may open and cause the product to drop. Dropping the product may cause injury or product failure.
• Carry the product safely by using the handle(❶) at the bottom of the product with both hands.
Installing the product
Installation Location Requirements
• If there is not enough room for air suction, the air purification performance may be affected.
- At humidity levels of 40 % – 70 %, the product's guaranteed performance standards can be achieved.
• Do not install the product near direct sunlight or bright lighting.
- Doing so may cause discoloration of the product.
PRODUCT OVERVIEW
- Air Outlet
• Emits air purified by the filter. - Air Quality Light
• Indicates the current air quality by color (green, yellow, orange, red). - Display Panel
• Use it to check the settings of the appliance and the air quality. - Control Panel
• Sets the appliance functions. - PM1.0 (Super Ultra-Fine Dust) Sensor
• Detects the dust concentration levels. - Filter
• Minimizes fine particles, dust, possible sources of sick house syndrome, smog, and other odors. - Handle
• Use it to carry and move the product. - Air Inlet
• Air is sucked into the air purifier through the air inlet.
• The front and rear covers can be removed separately.
FILTER
- Deodorization Filter
• This filter removes smog-causing substances (SO2, NO2), sick house syndrome-causing substances (toluene, formaldehyde), and household odors (ammonia, acetic acid, acetaldehyde). - Dust Collection Filter
• Minimizes PM1.0 and cigarette smoke from the air. - Filter Handle
• Used to remove or install the filter.
• The side with the handle should face upwards. - Ultra-Fine Filter
• The Ultra-Fine Filter is attached to the exterior of the filter and primarily removes household dust with large particles from the air.
- Do not forcefully separate the filters, as the filters are attached.
- Do not throw the filters or use them for other purposes.
This guide was created for all air purifier models. Images and content presented herein may differ from your product.
