Driving noises are mostly generated by foreign objects.
Check the side rotating brush, the rotating brush, the front caster, the wheel and the dust bin.
Noise will be louder when in turbo mode.
On a carpet or rough floor, the floor master function operates in turbo mode.
Noises are generated when the robot vacuum cleaner rotates.
There is a spring on the wheel, so when it rotates, the spring absorbs shocks and the sounds are generated.
Try this
How to disassemble, assemble or clean the front caster
① Insert a flat headed screw driver below the front wheel.
② Lift up a flat headed screw driver to separate the wheel.
③ After separating it, remove foreign objects.
④ Strongly press the top of wheel to reassemble it.
How to clean the rotating brush on the side and the main rotating brush
① Using a cross headed screw driver, separate the center screws off the rotating brush on the side.
② Pull the rotating brush on the side to separate it from the main body.
③ Using a cleaning brush, remove foreign objects.
④ Press and pull the hook to separate the rotating brush cover.
⑤ Grab the rotating brush and push it toward the yellow protrusion.
⑥ Lift the rotating brush to separate it.
⑦ Use a vacuum cleaner to clean the rotating brush.
If hairs are intertangled, use a scissor to cut them and then remove them.
⑧ Remove foreign objects from the rotating brush fixing unit.
If the smart diagnosis result is ok, then reset the roboking for use.
How to reset the product
※ Keep the roboking about 50cm away from the charging station.
① While the roboking is turned on, press and hold down the Turbo/HOME button for 3 to 5 seconds.
② Check if all the LED lamps are lit.
③ Press the [Start/Stop] button and the LED lamp to reset.
This guide was created for all models, so the images or content may be different from your product.
