Installation and Product Overview [Air Purifier]

Installation and product overview [Air Purifier]

Congratulations on your purchase of this LG Air Purifier product.

INSTALLATION

Unpacking the Appliance

1. Take the product out of the box, and remove the packaging and tape attached to the product.
2. While facing the front of the product, hold and gently pull both sides of the air inlet (cover) to remove it.
             • The side with the LG logo on the display of the product is the front of the product.
   

    
   

3. Remove the filter and dispose of the packaging.
   

    
   

4. Install the filter in the product.
             • Make sure that the side with the filter handle (❶) is facing up.
   

    
   

5. To reinstall the cover, insert the tabs at the bottom of the cover into the groove at the bottom of the product and close the cover.
   

    
   

Transportation Requirements

• Before moving or storing the product, wrap the cord around the lower part of the product to keep the power plug from touching the floor.
   - Failure to do so may damage the power plug or scratch the floor.
• Do not transport the product by holding its exterior cover.
   - The cover may open and cause the product to drop. Dropping the product may cause injury or product failure.
• Carry the product safely by using the handle(❶) at the bottom of the product with both hands.

 

Installing the product

Installation Location Requirements

• If there is not enough room for air suction, the air purification performance may be affected.

 

• The performance of the product may differ depending on the operating environment (considering factors such as temperature and humidity).
   - At humidity levels of 40 % – 70 %, the product's guaranteed performance standards can be achieved.
• Do not install the product near direct sunlight or bright lighting.
   - Doing so may cause discoloration of the product.

PRODUCT OVERVIEW

 

1. Air Outlet
             • Emits air purified by the filter.
2. Air Quality Light
             • Indicates the current air quality by color (green, yellow, orange, red).
3. Display Panel
             • Use it to check the settings of the appliance and the air quality.
4. Control Panel
             • Sets the appliance functions.
5. PM1.0 (Super Ultra-Fine Dust) Sensor
             • Detects the dust concentration levels.
6. Filter
             • Minimizes fine particles, dust, possible sources of sick house syndrome, smog, and other odors.
7. Handle
             • Use it to carry and move the product.
8. Air Inlet
             • Air is sucked into the air purifier through the air inlet.
             • The front and rear covers can be removed separately.

FILTER

 

1. Deodorization Filter
             • This filter removes smog-causing substances (SO2, NO2), sick house syndrome-causing substances (toluene, formaldehyde), and household odors (ammonia, acetic acid, acetaldehyde).
2. Dust Collection Filter
             • Minimizes PM1.0 and cigarette smoke from the air.
3. Filter Handle
             • Used to remove or install the filter.
             • The side with the handle should face upwards.
4. Ultra-Fine Filter
             • The Ultra-Fine Filter is attached to the exterior of the filter and primarily removes household dust with large particles from the air.

This guide was created for all air purifier models. Images and content presented herein may differ from your product.