Once the product is repaired, flow rate detection will function to enable precise temperature control.
However, if ambient water is dispensed instead of hot water post-repair or installation, it might suggest a failure in flow rate detection.
In case of such a failure, even if hot water is selected, ambient water will be dispensed continuously without stopping.
Try this
Dispense hot water into a container with a volume of at least 2L and wait until the hot water stops dispensing automatically.
Once flow rate detection is completed, the purifier will stop dispensing automatically.
Flow rate detection may take up to 10 minutes.
If flow rate detection is not initiated (i.e. when no hot water is dispensed), please disconnect and reconnect the power plug.
Then, select hot water and press the Dispense button to start flow rate detection.
This guide was created for all models, so the images or content may be different from your product.
