The steam nozzle can be used in steam mode and normal mop mode.
Try this
Preparing for use before cleaning works
1. Press the PUSH button(ⓛ) to separate the water bucket and open the cap(②) to fill the injection cup(③) with water.
Close the cap(②) and assemble the water bucket with the nozzle.
2. Soak the both sides of the mop pad in water and completely wring them for dryness. After that, attach it by aligning it with the center of the mop pad.
Use the dedicated steam mop pad included in the package provided when you purchased it.
Make sure to soak in water when using the safe steam mode.
Cleaning in safe steam mode
➔ During operation in safe steam mode, the battery pack LED is lit in red.
1. Insert the battery pack(②) into the safe steam mop pad nozzle(③) and insert the fully charged sub battery(①) into the battery pack.
※ Fully insert the battery pack and the battery until you hear the clicking sound.
2. Insert the safe steam mop pad nozzle into the length extension pipe and connect it to the main body.
Press the power button(④) on the main body to turn on the safe steam mode and start preheating.
※ During preheating, the front LED of the nozzle will flicker.
It takes approximately 40 seconds to preheat.
Cleaning in general mop pad mode
➔ During operation in general mop pad mode, the battery pack LED is turned off.
1. If you turn on the power of the main body without inserting the battery pack or battery, then it will operate in general mop pad mode.
2. While in safe steam mode, if you press the steam button on the battery pack, you can switch to general mop pad mode.
3. While in safe steam mode, if battery is discharged, it will switch to general mop pad mode.
Things you must know when using the safe steam mop pad
How to clean or store the safe steam mop pad nozzle
Right after cleaning works, the nozzle or mop pad might be very hot, so make sure to cool it down sufficiently before cleaning the nozzle.
This guide was created for all models, so the images or content may be different from your product.
