Try this
C-type installation guide: if there are no holes in the desk for cables.
➔ Basic installation requirements - desk thickness: less than 3.54 inches, desk depth: at least 4.56 inches.
- The default stand setup is assembled with a C-type grip and included in the box.
- Installation is not possible if the desk is box-shaped or the top is thicker than 90mm.
- For safety, make sure to fully insert the grip inside and tighten the screw during installation.
Installation is not possible if there is a structure protruding from the bottom.
➔ Install as follows depending on the thickness of the desk.
1. Desk thickness: 1.57 inches or less; insert the screws into holes 1 and 2.
2. Desk thickness: between 1.18-2.56 inches; insert the screws into holes 2 and 3.
3. Desk thickness: between 2.16-3.54 inches; insert the screws into holes 3 and 4.
T-type installation guide: if there are holes in the desk for cables.
➔ Basic installation requirements - desk thickness: less than 2.36 inches, diameter of cable hole: φ0.78-1.57 inches.
- Reassemble with the T-type grip included in the box and install it.
- Make sure that the thickness is the same on both sides of the installation.
➔ How to install
- Remove the screw of the C-type grip and reassemble it with the T-type grip provided in the package.
- Check the direction of the monitor and install the stand to the cable hole.
- The direction that the arrow points on the top of the grip indicates the direction in which front of the monitor should face.
- Assemble the rubber pad and handle and tighten clockwise.
- The rubber pad is not included separately and should be utilized after separating the components set up inside the C-type grip.
※ Electric screwdrivers should not be used.
This guide was created for all models, so the images or content may be different from your product.
