The LG 9,800 BTU 115v Through-the-Wall Air Conditioner, Model # LT1016CER does not have a DC Inverter Controlled Compressor. Rotary compressors are mostly used, but we do not have access to the engineering notes to verify that...^Ivan

The LG 10,000 BTU 115v Through-the-Wall Air Conditioner, Model # LT1016CER does not have louvers in the sides and the top like a Window Air Conditioner does and only has vents on the back. It pushes the hot air from the motor out through the vents in the back of the unit so that it doesn't heat the room...^IFV

The ENERGY STAR® Qualified LG 10,000 BTU 115v Through-the-Wall Air Conditioner, Model # LT1016CER has to be plugged into a dedicated (its own individual outlet) standard 125 V, 3-wire grounding receptacle protected by a 15 A time delay fuse or 15 A circuit breaker. The NEMA configuration for the outlet is 5-15R (i.e. Two parallel vertical slots over a round grounding hole). The information can be found in the product's owner's manual which can be downloaded from https://www.lg.com/us/support/product/lg-LT1016CER.AWYAUSH ...^IFV

The W x H x D dimensions for the sleeve that the LG 10,000 BTU 115v Through-the-Wall Air Conditioner, Model # LT1016CER fits into, the LG Thru-the-Wall Air Conditioner 26" Wall Sleeve, Model # AXSVA1, are 25 7/8" x 15 17/32" x 16 23/32" . All wall sleeves that are used to mount this air conditioner must be in good structural condition and must have a rear grille to securely attach the air conditioner. We strongly recommend the removal of the old wall sleeve and install the new LGE Wall Sleeve, but if you decide to keep your existing wall sleeve, you have to redirect the louvers at the back of the wall sleeve. If you do not redirect the louvers, you run the risk or poor performance or product failure which is not covered under the warranty. This unit will fit into a White-Westinghouse, Frigidaire or Carrier (52F series) wall sleeve with W x H x D dimensions of 25 1/2" x 15 1/4" x 16, 17 1/2 or 22", a General Electric/Hotpoint wall sleeve with W x H x D dimensions of 26" x 15 5/8" x 16 7/8", a Whirlpool wall sleeve with W x H x D dimensions of 25 7/8" x 16 1/2" x 17 1/8" or 23", a Fedders/Emerson wall sleeve with W x H x D dimensions of 27" x 16 3/4" x 16 3/4" or 19 3/4" or an Emerson/Fedders wall sleeve with W x H x D dimensions of 26 3/4" x 15 3/4" x 15", a Carrier wall sleeve (51S series) with W x H x D dimensions of 25 3/4" x 16 7/8" x 18 5/8", a Friedrich wall sleeve with W x H x D dimensions of 27" x 16 3/4" x 16 3/4". The owner's manual for the air conditioner has detailed instructions for the different procedures that you have to use to prepare the wall sleeves for installation...^IFV