You may insert and remove the battery and
CAM Plus module in the following ways:
Inserting the battery
the battery and module to the spots marked below, and then insert in order.
2. Slide the module gently into the
device until it is fully attached.
not press the detach button when inserting the module into the phone.
battery must be inside the module before inserting into the phone.
Removing the battery
1. Press the detach button on your phone
and make sure the module is slightly off the device.
2. Hold the middle of the module and
detach it completely from the phone.
3. With one hand holding the battery and
the other hand on the module, remove them in the directions shown below.
sure you are not moving when detaching the module.
care not to hurt your hand or fingers when sliding in or out the module.
cautions to prevent any damage to the product or module.
note that placing the battery or module incorrectly may cause power-on failure
or damage to the product.
not compatible with third-party CAM Plus modules. Be sure to use a module from
the same provider.
device will not boot in case of empty battery. (CAM Plus' battery is not used