Do you wish to connect the water supply hose of the washing machine to a faucet? Do you wish to know how to extend the water supply hose if it is too short?
A water supply hose is a hose used to connect a washing machine to a faucet.
If you move your washing machine and install it in a new location, the water supply hose can be connectedly easily only using a Phillips screwdriver and a flat-head screwdriver.
The connection method may differ depending on the type of water supply hose and the shape of the faucet. Please check them first.
If you wish to extend the length of the water supply hose because it is short, please purchase a water supply hose suitable for the washing machine model from the LG Electronics homepage’s [care goods/consumables] section or the nearest LG Electronics service center and use it as a replacement.
- Turn off the washing machine and the faucet before you connect or extend the water supply hose.
- The default setting of a washing machine is cold water.
If you use only one hose, make sure to connect it to the cold water outlet.
Try this
Have you purchased a new washing machine or would you like to move the product and connect it to a water supply hose?
➔ Please make sure that the water supply hose is not pressed, kinked or bent.
1. There is a Push switch in the middle of the water supply hose.
Press the Push switch to disconnect the coupling device and hose.
If it’s not separated, water may leak as it is not fully tightened.
2. Turn 2 of the 4 screws in the coupling device counterclockwise and loosen them.
3. Loosen the plastic part of the coupling device by turning it clockwise about 3 times as shown in the figure.
4. Insert the coupling device of the faucet from step (3) with pressure as shown in the figure, and then turn the two screws loosened clockwise to tighten the fitting.
At this time, insert the orange coupling device into the hot water faucet and the light blue coupling device into the cold water faucet.
5. Tighten the coupling device counterclockwise.
Then insert the water supply hose that was separated in step (2).
Press the Push switch and press until you hear a click.
6. Connect the water supply hose to the washing machine.
7. After installation, be sure to turn on the faucet to check for any water leaks.
세탁기의 전Replug the power plug of the washing machine into the power outlet, turn on the power, and operate the [water supply] to check if the water pressure is appropriate.
Do you wish to extend the water supply hose because it is too short?
➔ First, please purchase a water supply extension hose at an LG Electronics distributor or LG Electronics service center.
1. Connect the newly purchased extension water supply hose to the faucet after disconnecting the old water supply hose.
Connect the end of the new water supply hose to the existing hose to complete the installation.
2. Remove the existing water supply hose from the faucet.
3. Connect the newly purchased water supply extension hose to the faucet by referring to the One-Touch Type Water Supply Hose Connection above.
4. Connect the end of the extension hose to the existing hose using the intermediate coupling device (connector) of the water supply hose.
5. If you need to select between either cold water or hot water outlets, be sure to connect to the cold water.
If you select a water temperature instead of cold water when operating the washing machine, only cold water will be supplied to the machine.
6. After installation, be sure to turn on the faucet to check for any water leaks.
Replug the power plug of the washing machine into the power outlet, turn on the power, and operate the [water supply] to check if the water pressure is appropriate.
This guide was created for all models, so the images or content may be different from your product.
