[Title]
LG Front Load Washing Machine - Shipping Materials & Vibration
[Narrator]Welcome to a LG support video.
Here we will discuss possible ways to reduce vibration in your LG front load washing machine.
If your machine is experiencing excessive vibration, some reasons may be:
Single items
Unbalanced mix heavy items with light items
Tangled load
Bulky items or comforters
Sometimes avoiding these conditions for your washer will eliminate vibration.
If this is still occurring, some other issues could be.
Extraneous shipping materials
or Leveling
There are 2 elements from shipping that could still be attached to your washer causing excess vibration.
The first are for shipping bolts attached to the rear of your washing machine.
If the bolts are still there, remove them by using the wrench provided with your washer.
Loosen the bolts by turning them counterclockwise.
Once loosened pull them out.
Save these bolts for future use.
If you need to transport the washer elsewhere, the bolts will be necessary to prevent damage to the internal components.
Locate the 4 hold caps included in the accessory pack that you received with your washing machine, and install them into the shipping bolt holes.
Warning:
Failure to remove the shipping bolts and retainers before use may cause severe vibration and noise, which can lead to permanent damage to the washer.
The second possible cause of excessive vibration is a shipping block that might be caught under the washer.
LG front load washers are shipped with a foam block in the base to support the tub during shipping.
Tilt the washer back to check for the foam block.
Caution! Do this with 2 people to avoid injury.
If wedged under the tub, simply remove the foam block.
The drum of your washer spins at very high speeds, to minimize vibration, noise and unwanted movement.
Your washer must be level and installed on level, solid flooring with properly adjusted feet.
To check this, first place a level across the top of your washer and adjust the leveling feet until your washer is level from side to side and front to back.
After any adjustment, make sure that the lock nuts on all 4 feet are tight.
If any of the lock nuts are loose, tighten them with a wrench included with the washer.
Next, check that all 4 leveling feet are firmly and evenly in contact with the floor.
To test this, rock the washer from corner to corner in each direction.
If the washer rocks more in one direction than the other, then the feet are not properly adjusted.
Loosen the lock nut on the foot that is rocking and adjust the foot up or down until the rocking is minimized.
And is the same in both directions.
Tighten the lock nut.
Once you have made these adjustments, test the machine by setting it to the spin cycle with a load of laundry.
Load the washing machine with a light load.
Press the power button.
Then press the rinse and spin cycle option.
Press the start button.
Check if water is supplied and that the washing machine does not rock or vibrate excessively.
And that it drains well during the spin cycle.
If the washing machine rocks and vibrates excessively, try leveling the washing machine.
Loosen the locknut on one of the front feet.
Adjust the foot up or down until the vibration is minimized.
Once this adjustment has been made, be sure to tighten the locknut.
Your washing machine is now ready for quieter use.
Thank you for watching the LG customer support channel.
We hope you enjoy your LG experience.
