Wired Network Setup

CONNECTING TO A WIRED NETWORK

Before you can connect to your network you will need to make sure you have the necessary components:

LG Remote

LAN Cable

Modem

Router(Optional)

Do you have a preexisting wired network?

If you have a network already set-up andworking for other devices, simply connect the LAN cable to the back of the LG device from the back of the router/modem.

This must be a CAT5 or CAT6 cable with a RJ45 connector.

If you do not have a wired home network already set-up you will need to have a broadband modem (Cable, DSL, etc.) and a router, which is sometimes combined with a modem if obtained from your service provider.

If all of these items are on hand, verify that the LAN cable is routed properly. A LAN cable must be connected from the modem to the router in order for the router to receive a network signal.

Connect the LAN cable from the modem/router to the back of the LG device.

This must be a CAT5 or CAT6 cable with an RJ45 connector.

Note: If you do not at least have a modem, you will not be able to set up a wired home network.

If all the necessary accessories are on hand, follow the on screen instructions and select Wired Network when prompted to select the connection type.

IP Settings

Auto IP Setting (Most Common)

Select Auto IP Setting from the on-screen menu.

Using the Auto Setting is the most common and simplest form of connecting to a network and will allow you to connect without entering in any information.

Manual IP Setting (advanced, Less Common)

If you prefer to set the Manual IP Settings, you may need to contact your Internet Service Provider to obtain the necessary IP information. You can attempt to do the following manually using the steps below.

Windows XP

Select the "Start" menu and highlight "Run" In the dialogue box, type "CMD" then click 'OK' In the command prompt window, type "ipconfig/all" then click 'Enter'. In the command prompt window, type "ipconfig/all" then click 'Enter'.

Windows 7

Select the "Start" menu > All Programs > Accessories > Command Prompt In the command prompt window, type "ipconfig/all" then click 'Enter'. The IP address of the computer, Subnet Mask, Gateway, and DNS Server is displayed.

By knowing the IP address of the computer or a router on the network, you can assign this device an IP address. You simply change the last set of numbers to a number that is not being used by any other device on the network.

Example: Router IP is "192.168.1.1". Change the last digit to "192.168.1.2 or 192.168.0.3"on the LG device to assign a static IP address.

The additional information (Subnet Mask, Gateway, DNS) from the command window can be entered into the remaining fields of the IP settings on the LG device.