-
Power on
Press Power Button
to turn on the power.
- It takes 30 minutes of continuous operation to reach the desired humidity level the first time the product is used.
- The display shows the current humidity level.
-
Humidity
Press the Up
/ Down
Buttons to change humidity
- The desired humidity level can be set in 5-percent increments from 30-80%.
- The display shows the desired humidity level while it is being set, then reverts to the current humidity level after 5 seconds.
- The current humidity level is displayed in 5-percent increments from 25-90%. If the humidity level is outside the range, the display continues to show either 25% or 90%.
-
Fan speed
Press Fan speed
to change the fan speed
- The fan speed has two levels: low or high.
-
Power Off
Press to Power Button
Note:
• If the product is restarted immediately after being shut down, to protect the compressor there is a 3-minute delay until the compressor begins operating.
• It is normal for the compressor to cause the product to vibrate while starting or stopping.
-
Power On
Press to Power Button
-
Timer
Press the Timer Button
to set the automatic shut off time.
- Press the button repeatedly to increase the time until shut off in 1-hour increments up to 12 hours.
-
Cancel
Press the Timer Button
- Press the Timer button repeatedly until the Timer light turns off.
Note: Empty the drain water bucket before setting the Timer function. If the water bucket becomes full during the Timer function, the Bucket Full light goes on and dehumidification stops.
