Is ‘Clean filter / Empty water container’ displayed when dryer powered “on”?
Cause and Symptoms
LG 24 inch wide compact condensing ventless dryers operate on 110 volt. Being that the electrical power at that level is insufficient to properly heat up an element warm enough to dry clothing, the technology employed is condensation. As such there will be water accumulation.
These dryers feature panel notification to that effect. If either “Clean Filter” or “Empty Water” notification light up ensure to clean the filter or empty and clean water container respectively before proceeding with drying up a load.
Try this
- It is normal that “Clean Filter” indicator light flash when power gets turned “on”.
- It is intended as a friendly reminder to clean the filter before each use for optimal performance results.
- Press the START button and the message will disappear.
If the filter gets clogged or “Empty Water” message lights up after running a cycle, make sure to clean the filter and the condenser, empty the water container and check the drain hose for possible leak prior to attempt drying the next load.
Warning Indicator Lights Meaning
Water Container Location
Emptying the Water Container
Condensed water is collected in the water container. Empty the water container after every use. Not doing so will affect the drying performance.
Note
- If the water container is full,
icon lights up and sounds while the appliance is running (empty water container indicator light icon may differ for some models)
- If the condensed water is drained out directly through the optional drain hose, there is no need to empty the water container.
Caution
If the laundry is not spun at high enough speed, while washing, energy consumption and drying time will increase. In some cases, the laundry display panel flashes “Empty Water Container” warning indicator light. Then, the dryer might stop. Increase SPIN speed, then press START button.
Regular Maintenance
- Pull out the water container.
- Empty the water container into the sink.
Caution
- Do not drink the condensed water or reuse it. Doing so could lead to health problems for people and animals.
- The water container is heavy when full. Hold the water container with two hands and be careful not to drop it.
- Refit the water container into the appliance. Push it fully into the appliance until it is in place.
- Press the Start/Pause button to run a cycle.
Cleaning the Condenser Unit
The condenser is a very important part of your dryer. This is where the moisture is removed from the air so there is no need for an outside exhaust. If the condenser is not properly maintained, it will greatly increase energy consumption and drying time. The condenser should be cleaned 3 or 4 times a year, or any time the Clean Condenser light blinks.
- Push the tab and open the condenser cover.
- Unlock the inner plate by rotating the locking levers on either side of the plate. Then slide the plate out of the opening.
- Carefully slide condenser straight out of the housing using finger ring at the center. Use care when handling the condenser to prevent damage that could reduce its efficiency.
- Thoroughly clean the condenser by running tap water through it from both the ends and the sides.
- Slide the clean condenser into the housing. Make sure it is oriented as shown in the drawing in step 3.
- Insert the inner plate into the opening in front of the condenser, then rotate the locking tabs to lock it in place. Then close the front cover.
Caution
- NEVER operate the dryer without the condenser in place.
- Do not operate the dryer with a dirty or clogged condenser. Doing so will increase energy consumption and drying times.
- Handle the condenser with care. Do not use sharp or hard objects to clean the condenser as this could damage the condenser.
- Do not operate the dryer with a damaged condenser. Doing so could result in leaking which may result in property damage
Draining Remaining Condensed Water
After drying clothes, a small quantity of condensed water may sit in the base of the appliance and cause odors. Drain the remaining water regularly to reduce any unpleasant odors from the appliance.
Note
- It's better to drain the remaining water when you are going to be away for a long time, because the remaining water will stagnate and cause odors.
- For best results, drain the remaining water before running Drum Care.
- The remaining water can freeze inside the main drain hose(s) and affect the drying performance in cold weather. Draining the remaining water can prevent damage to the appliance from unexpected freezing.
- Run the Air Dry cycle for 3 minutes, and then turn off the appliance.
- Unclip the drain tube under the appliance, remove the plug and drain the remaining water.
Note
Use the water collection tank if the optional drain hose is installed or the appliance is stacked on a washing machine.
- Reassemble the plug onto the drain tube and clip the drain tube back into its holder.
Caution
If the plug is not securely inserted into the drain tube, water will leak out and could cause damage.
