Installation Test Cycle [dryer]

Installation Test Cycle

A dryer installation test examines the condition of the exhaust system to guarantee optimal functioning. You should conduct the test after installing the dryer and then on a regular basis after that.

Test Exhaust System

Once you have completed the installation of the appliance, use this test to make sure the condition of the exhaust system is adequate for proper operation of the appliance. This test should be performed to alert you to any serious problems in the exhaust system of your home.

• Your appliance features Flow Sense, an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use.

Try this

Activating the Installation Test

1. Remove the drying rack (on some models) and literature, and then close the door.
   
   
   
   • Do not load anything in the drum for this test, as it may affect the accuracy of the results.
2. Press the Power button then IMMEDIATELY press and hold the Low Static and Options buttons.
   
   • This button sequence activates the installation test. A message will display if the activation is successful.
   
3. Press the Start/Pause button.
   
   • The appliance will start the test, which will last a few minutes. The heat will be turned on and the temperatures in the drum will be measured.
4. Check the display for results.
   
   • During the test cycle, monitor the Flow Sense display on the control panel. If the Flow Sense LED has not turned on when the cycle ends, the exhaust system is adequate. If the exhaust system is severely restricted, the Flow Sense LED will turn on. Other problems may also be shown with error codes. See the chart below for error code details and solutions.
     
     

     Error Code Chart

     Error Code	Possible Cause & Solution
     Temp sensor error	Temperature sensor failure - Turn off the appliance and call for service.
     Humidity sensor error	Humidity sensor failure - Turn off the appliance and call for service.
     High voltage Low voltage Power supply / Power issue	Electric dryer power cord is not connected correctly, or house power supply is incorrect. Reset circuit breaker or replace fuse. Do not increase the fuse capacity. House fuse is blown, circuit breaker has tripped, or power outage has occurred. If the problem is a circuit overload, have it corrected by a qualified electrician.
     Gas supply	Gas supply or service turned off. (Gas model only.) - Turn off the appliance and call for service.

     Note For more information see the dedicated virtual Help Library article addressing error code issues for further details and troubleshooting tips. The article is titled "Error Codes - Dryers".
   • If the Flow Sense LED indicates that the exhaust system is severely restricted, have the system checked immediately, as performance will be poor.
   
5. End of cycle.
   
   • At the end of the test cycle, a message will display. The test cycle will end and the appliance will shut off automatically after a short delay.