LG article.CT20098058-1430396982376-others Product Support: Manuals Warranty & More

Water remaining inside of dishwasher

Why does water remain inside dishwasher after wash has terminated?

Try this

Cause and Symptoms

Cause

Heated and sterilized water may remain after washing to prevent odor and backflow contamination.
Small amount of residual water is normal by design to protect seals and pump components.
Drain delay operation after cycle completion.
Improper drain hose installation or partial blockage.
Filter, sump, or check valve obstruction.

Symptoms

Small amount of clear water at bottom of tub (normal).
No drain error code.
Water level below filter.
Standing or dirty water indicates a drain issue.

Troubleshooting Steps

Residual water is sterilized as it is heated at high temperature from a previous cycle, therefore free from contamination.

residual water is safe from contamination

When a cycle starts, residual water is drained out and water fills up again.

Regardless of selected cycle, the first 60 seconds are dedicated at emptying tub of whatever water was left from the previous wash by draining it out.

Please be assured the product is safe to use. It is normal to find 50~100ml of water remaining in the sump (water evacuation) area.

Important Notes

HOWEVER, IF THE REMAINING WATER QUANTITY INSIDE TO TUB APPEARS TO EXCEED 50~100ml THEN YOU NEED TO ADDRESS THE FOLLOWING POTENTIAL REASONS :

Is there an error code appearing on the display panel. Error Code would read "OE"?

Check the drain hose whether food debris may have clogged it.

Could the drain hose have been inadvertently pinched or kinked, preventing the appliance from fully draining?
Is the drain hose loop underneath the sink a minimum of 20 inches in height to prevent backflow from the house drain?
Is the dishwasher properly leveled?

Incorrectly leveled dishwasher will cause water to remain inside.

Are you using Rinse Aid?

Not using Rinse Aid risks causing poor drying, therefore condensation accumulation.

FOR ADDITIONAL INFORMATION SUCH AS ERROR CODES & RESPECTIVE SIGNIFICATION, PLEASE CONSULT BELOW LINK:

Error Codes

For additional information such as Error Codes & Respective Signification and How To Clean Dishwasher and its Overall Maintenance, please consult to the link below:

Customer Concern & Testimonial Corner

Some customers have commented:

“The interior of the door and machine are very wet even after going through the drying cycle.”

Good observation!

Condensation drying principle is typically featured on most EnergyStar dishwashers on account it consumes lots less energy than radiant heat for that matter (… while dishes still come out slightly damp).

Once the final hot water rinsing completed, condensation forms on the stainless steel interior panels from drawing moisture off the dishes. Upon contact with the cooler stainless steel panel surface, condensed droplets of water slide down towards the drain.
For drier dishes, before removing them, leave the dishwasher door ajar a few minutes to let the ambient cool air dry out any remaining moisture inside.

If you have ever washed dishes manually in the sink, the ideal concept consisted of washing the dishes in soap induced hot water, rinsing dishes in cold water to remove any suds then place them in the rack to dry. It normally takes less than a minute for dishes and glassware to dry. Metal, wood and plastic utensils are less prone to quick drying and have to be wiped with a dry cloth.