Leveling adjustments

How to adjust level

Supply water until it reaches the height of the pulsating impeller wheel ’ s washing wings at the bottom of the tub. If and when the water slants to one particular direction, level the product using height adjustment legs. [Height adjustment legs are located only at the front.]

To make sure that washer is properly level, open the lid and look from above to see if it is same as shown below. If you have a level, check your washer with the level.

• To check if the washer is level side to side, close the lid and place a level at the back of the lid.
• To check if the washers is level fron to back, place a level at the side of the washer on the edge where the cabinet side meets the top cover.

Try this

1. Adjust the level of the product using legs at bottom front. If legs are extended out too long, it may cause vibration.

   
   
   
   

2. Place appropriate a number of height adjustment shims to level the product. (Sold separately/Do not use more than four shims.) Height adjustment shims made of rubber should be placed on the surface.

   
   
   
   
   How to use the adjusting plates Use the adjusting plates to level the washer when the adjustable legs cannot cover the gap.
   
   

3. Try to rock the washer to see if it is firmly installed